#18208 [Fbk->NoF]: create_socket Undefined

ID: 18208 Updated by: jason@php.net Reported By: fouriedj@telkom.co.za -Status: Feedback +Status: No Feedback Bug Type: Sockets related Operating System: RedHat 7.1 PHP Version: 4.2.1 New Comment: No feedback was provided. The bug is being suspended because we assume that you are no longer experiencing the problem. If this is not the case and you are able to provide the information that was requested earlier, please do so and change the status of the bug back to "Open". Thank you. Previous Comments: ------------------------------------------------------------------------ [2002-07-10 09:51:16] jason@php.net Are you sure that you are not somehow conflicting with another version of php that is installed on your system. (Redhat 7.1 includes a very early version of 4). If you are positive that the php you are running -m on is the same as the one you compiled, then run the following command(adjust the paths appropriately of course): nm /usr/local/bin/php | grep socket_create If you truly have sockets compiled in, you will see the following output: 080bd854 T zif_socket_create 080bc9d4 T zif_socket_create_listen 080c1128 T zif_socket_create_pair If not, then you are most likely rebuilding different configurations in the same build area. (This can be bad) If this is the case: make clean rm config.cache ./configure --enable-sockets make -Jason ------------------------------------------------------------------------ [2002-07-08 01:14:05] fouriedj@telkom.co.za Here is a script that I am looking at, it is part of the php documentation. #!/usr/local/bin/php -q <?php error_reporting (E_ALL); /* Allow the script to hang around waiting for connections. */ set_time_limit (0); /* Turn on implicit output flushing so we see what we're getting * as it comes in. */ ob_implicit_flush (); $address = '192.168.1.53'; $port = 10000; if (($sock = socket_create (AF_INET, SOCK_STREAM, 0)) < 0) { echo "socket_create() failed: reason: " . socket_strerror ($sock) . "\n"; } if (($ret = socket_bind ($sock, $address, $port)) < 0) { echo "socket_bind() failed: reason: " . socket_strerror ($ret) . "\n"; } if (($ret = socket_listen ($sock, 5)) < 0) { echo "socket_listen() failed: reason: " . socket_strerror ($ret) . "\n"; } do { if (($msgsock = socket_accept($sock)) < 0) { echo "socket_accept() failed: reason: " . socket_strerror ($msgsock) . "\n"; break; } /* Send instructions. */ $msg = "\nWelcome to the PHP Test Server. \n" . "To quit, type 'quit'. To shut down the server type 'shutdown'.\n"; socket_write($msgsock, $msg, strlen($msg)); do { if (FALSE === ($buf = socket_read ($msgsock, 2048))) { echo "socket_read() failed: reason: " . socket_strerror ($ret) . "\n"; break 2; } if (!$buf = trim ($buf)) { continue; } if ($buf == 'quit') { break; } if ($buf == 'shutdown') { socket_close ($msgsock); break 2; } $talkback = "PHP: You said '$buf'.\n"; socket_write ($msgsock, $talkback, strlen ($talkback)); echo "$buf\n"; } while (true); socket_close ($msgsock); } while (true); socket_close ($sock); ?> Regards Daniel Fourie ------------------------------------------------------------------------ [2002-07-07 07:59:31] derick@php.net Please provide a short script with which we can reproduce it. Derick ------------------------------------------------------------------------ [2002-07-07 07:56:24] fouriedj@telkom.co.za I have got php-4.2.1 installed on Linux RedHat-7.1. I am trying to write a clent/server based application but cannot seem to get it to work. The function create_socket always comes back with the following error (Undefined function socket_create). I have compiled my source with the option --enable-sockets and if I do a ( php -m) I do see that sockets is available, event if I check in phpinfo() I see that it is enabled. I loocked all over the internet asked a lot of people but still no answer. Please can you help me with this. Regards Daniel Fourie ------------------------------------------------------------------------ -- Edit this bug report at http://bugs.php.net/?id=18208&edit=1