#19924 [Com]: zlib.lo: file not recognized: File truncated

ID: 19924 Comment by: jms18@weatherhead.cwru.edu Reported By: jms18@weatherhead.cwru.edu Status: Bogus Bug Type: Compile Failure Operating System: Debian Linux 3.0 PHP Version: 4.3.0-pre1 New Comment: Just in case anyone stumbles upon this page with the same problem. Here is what I did that eventually got it to work. % rm -rf ./config.cache % ./configure --enable-trans-sid \ --with-mysql=/usr/local/mysql \ --with-png=/usr/local --with-pg-dir=/usr/local \ --with-freetype \ --with-zlib --with-zlib-dir \ --with-gd=/usr/local \ --with-apxs2=/usr/local/apache/bin/apxs % make clean # not sure if this next step was necessary, but I did it % make depend % make % su % make install Thanks, Jeremy Previous Comments: ------------------------------------------------------------------------ [2002-10-16 12:36:45] jms18@weatherhead.cwru.edu I tried using just --with-zlib with no path specified, and it produced the same error. Right after submitting the bug, I downloaded 4.2.3 and built it using the same configure line (without the mm, though because that produced an error with Apache2). So, 4.2.3 worked, but 4.3 produced an error. I'll try a make clean and see if that does anything for me. ------------------------------------------------------------------------ [2002-10-15 22:29:27] sniper@php.net Try doing 'make clean'..and btw. just using --with-zlib should work (ie. no path) This is not any bug anyway, you're just doing something wrong. ------------------------------------------------------------------------ [2002-10-15 16:56:36] jms18@weatherhead.cwru.edu I should probably also mention (because, for some reason, I forgot to do so) that this is being compiled as a DSO for Apache 2.0.43. ------------------------------------------------------------------------ [2002-10-15 16:08:41] jms18@weatherhead.cwru.edu I configured PHP with the following: ./configure --enable-trans-sid \ --with-mysql=/usr/local/mysql \ --with-mm=../mm-1.2.1 \ --with-png=/usr/local \ --with-png-dir=/usr/local \ --with-freetype=/usr/local \ --with-zlib=/usr/local \ --with-zlib-dir=/usr/local \ --with-gd=/usr/local \ --with-apxs2=/usr/local/apache/bin/apxs The configuration goes fine. When I execute 'make', the following error occurs: sapi/apache2filter/php_functions.lo main/internal_functions.lo -lmm -lmysqlclient -lgd -lpng -lz -lz -lcrypt -lresolv -lm -ldl -lnsl -lcrypt -ldl -o libphp4.la ext/zlib/zlib.lo: file not recognized: File truncated collect2: ld returned 1 exit status make: *** [libphp4.la] Error 1 I tried a couple of things. I made sure my ld.so.conf was up to date (just in case). I tried to point --with-zlib and --with-zlib-dir against the un-tarred source of zlib (version 1.1.4) a la: --with-zlib=../zlib-1.1.4 \ --with-zlib-dir=../zlib-1.1.4 I tried just specifying '--with-zlib' with no path parameter, but nothing worked. Thanks guys! ------------------------------------------------------------------------ -- Edit this bug report at http://bugs.php.net/?id=19924&edit=1