Bug #16984 Updated: make test refuses to run

ID: 16984 Updated by: matthew@devney.net Reported By: matthew@devney.net Status: Open Bug Type: Compile Failure Operating System: FreeBSD 4.5; Linux 2.4.19-pre6 PHP Version: 4.2.0 New Comment: I have verified the problem on 2 different Linux-2.4.28 machines. The same error occurs regardless of whether I have used --enable-cli or not. Previous Comments: ------------------------------------------------------------------------ [2002-05-03 05:09:15] matthew@devney.net # make test make: don't know how to make /usr/src/php-4.2.0/sapi/cli/php. Stop History: The first time I ran configure, I did: ./configure --with-mysql=/usr/local --enable-cli That build ran fine, and make test ran (though it failed just under half its tests.) I decided I didn't want the cli, so I did: # make clean # ./configure --with-mysql=/usr/local This time, the make finished, again with no errors of note, but the make test refuses to run with the error given above. After trying make distclean and rerunning a couple times, I finally rm -rf php-4.2.0 and untarred again, for a fresh build tree. Now, I get the same error, again referencing sapi/cli/php. It is worth noting that, on subsequent tries, if I include --enable-cli, make test will run; if I do not, it will not. This, despite a completely clean build tree (rm -rf and start over). I can only assume that it is placing the config.cache somewhere outside the build tree. Version 4.1.2 does not exhibit the same behaviour. Linux (2.4.19-pre6) has a similar error message: make: *** No rule to make target /home/matthew/src/php-4.2.0/sapi/cli/php', needed by test'. Stop. I assume these are differences between gmake and BSD make, both referencing the same problem. ------------------------------------------------------------------------ -- Edit this bug report at http://bugs.php.net/?id=16984&edit=1