PHP 4.0 Bug #6515 Updated: MSVCRT.DLL exists in C:\WINNT\SYSTEM32 but is the wrong version.

ID: 6515 Updated by: sniper Reported By: down@beer.com Status: Closed Bug Type: *General Issues Assigned To: Comments: No feedback. Previous Comments: --------------------------------------------------------------------------- [2000-09-03 12:40:05] jmoore@php.net OK One or two ways you can try to do this. Firstly try to rename the dll then copy the new one in. otherwise use a boot disk (Win 98/95) boot into dos and copy it accross while in DOS. This is one of the major problems with dll's because they donot enable versioning. I would strongly advise you to make a back up copy of your current dll incase somthing else breaks. Did you upgrade to Win2k pro or was it a clean install as I did a clean install and never had this problem with the DLL. Anyway, make a back up copy first!!! James --------------------------------------------------------------------------- [2000-09-03 12:21:53] down@beer.com The readme file states "The DLLs that need to be copied are MSVCRT.DLL (it may already exist in there) and PHP4TS.DLL." MSVCRT>DLL allready exists in the system folder and is in use by windows even in safe mode so I couldn't replace it with your version. When I run PHP it gives me the following error message: "The procedure entry point ??_U@YAPAXI@Z could not be located in the dynamic link library MSVCRT.dll" --------------------------------------------------------------------------- Full Bug description available at: http://bugs.php.net/?id=6515