Re: Bug in autoconf report

----- Original Message ----- From: <derick@php.net> To: "Jeroen van Wolffelaar" <jeroen@A-Eskwadraat.nl> Cc: "PHP Development List" <php-dev@lists.php.net> Sent: Tuesday, September 25, 2001 7:46 PM Subject: Re: [PHP-DEV] Bug in autoconf report > On Tue, 25 Sep 2001, Jeroen van Wolffelaar wrote: > > > [jeroen@richard]~/scratch/tmp/php4-cvs> ./buildconf > > buildconf: checking installation... > > buildconf: autoconf version 2.13 (ok) > > buildconf: automake version 1.4-p4 (ok) > > buildconf: libtool version 1.4 (ok) > > WARNING: automake and libtool are installed in different > > directories. This may cause aclocal to fail. > > continuing anyway > > so don't do that... install them into the same dir. This causes the errors > below probably. <snip> > > Note: after I solved that warning about automake & libtool not being in > > the same dir, the error remainded the same. (I copied the automake executable to the same dir as the libtool executable) > > > > This is a fresh CVS of 3 minutes ago. > > > > > > When I run configure arterwards: > > > > ./configure > > <snip> > > Configuring Zend > > checking build system type... i686-pc-linux-gnu > > checking for ld used by GCC... /usr/bin/ld > > checking if the linker (/usr/bin/ld) is GNU ld... yes > > checking for BSD-compatible nm... /usr/bin/nm -B > > updating cache ./config.cache > > ./ltconfig: ./ltconfig: No such file or directory > > configure: error: libtool configure failed > > > > (indeed, 'ltconfig' doesn't exist) > > > > Also note that I didn't ever succesfully build PHP directly from CVS - I > > didn't have libtool 1.4 till yesterday > > > > --Jeroen