Bug #14675 Updated: ./configure line not properly reflected in phpinfo()

ID: 14675 Updated by: sander Reported By: junk-php@aontic.com Old Status: Open Status: Bogus Bug Type: *General Issues Operating System: 2.4.7-10smp #1 SMP / RH 7.2 PHP Version: 4.1.0 New Comment: Run "make clean" Previous Comments: ------------------------------------------------------------------------ [2001-12-23 15:38:15] junk-php@aontic.com When compiling PHP statically with Apache I've observed the following strange and very frustrating behavior. in /php ./configure OptionA in /apache ./configure --activate... make then phpinfo() reports the proper ./configure line it was compiled with. Then do something like in /php ./configure --without-mysql in /apache make (using earlier ./configure) now phpinfo() reports the old configuration line, but Mysql for example is now not present. removing config.cache between compiles in /php doesn't fix things, but a make clean does. Doesn't appear to depend on the /apache build process since make clean on the apache side changes nothing, not does a new /apache ./configure. The functionality changes properly in every case. A /php ./configure WITH mysql generates the mysql section in phpinfo(), but the phpinfo() configuration line might remain --without-mysql, even though the mysql extension is listed in the very same phpinfo. Now I'd call this so much nitpicking if I wasn't going to building php a couple of hundred times. I'd obviously like to avoid doing a make clean between each slightly changed build. Since the underlying functionality seems to change properly I'm assuming I either missed some obvious instruction, or that there is simple bug or documentation update that should happen to fix things up. ------------------------------------------------------------------------ Edit this bug report at http://bugs.php.net/?id=14675&edit=1