Bug #14146 Updated: Compiles fine, but PHP binary and module just exit
| From: | yohgaki@php.net | Date: | Mon, 04 Feb 2002 07:23:43 +0000 |
| Subject: | Bug #14146 Updated: Compiles fine, but PHP binary and module just exit | ||
| References: | 1 | Groups: | php.dev |
| Request: | Send a blank email to php-dev+get-79053@lists.php.net to get a copy of this message | ||
ID: 14146
Updated by: yohgaki@php.net
Reported By: ivo@sara.nl
-Status: Open
+Status: Bogus
Bug Type: Reproducible crash
Operating System: AIX
PHP Version: 4.0.6
New Comment:
The version of PHP that this bug was reported in is too old. Please
try to reproduce this bug in the latest version of PHP (available
from http://www.php.net/downloads.php
If you are still able to reproduce the bug with one of the latest
versions of PHP, please change the PHP version on this bug report
to the version you tested and change the status back to "Open".
Previous Comments:
------------------------------------------------------------------------
[2001-11-22 04:23:53] ivo@sara.nl
The times I used gdb can be counted on one hand (never was involved in
a *huge* programming project, so the need for extensive debugging has
always been minimal), but here you go:
(this is the same result I get with PHP4.1.0RC3 unfortunately)
(gdb) run
Starting program: /san/stst/ststivo/php/bin/php
Program exited with code 06.
(gdb) bt full
No stack.
------------------------------------------------------------------------
[2001-11-21 12:30:55] sniper@php.net
And you should also try the PHP 4.1.0RC3 from:
http://download.php.net/~zeev/php-4.1.0RC3.tar.gz
------------------------------------------------------------------------
[2001-11-21 12:30:05] sniper@php.net
What does 'bt full' output? (in GDB)
------------------------------------------------------------------------
[2001-11-20 10:08:16] ivo@sara.nl
Additional note: PHP 3.0.18 does not have this problem, but all the
older 4.x versions available on php.net (4.0.5, 4.0.4pl1) behave
exactly the same as 4.0.6 after compilation.
------------------------------------------------------------------------
[2001-11-20 07:21:49] ivo@sara.nl
strace is available, but I haven't got much experience with it. Perhaps
it works differently under Linux, but 'strace php' is not the way on
AIX.
Purpose
Prints STREAMS trace messages.
Syntax
strace [ mid sid level ] ...
------------------------------------------------------------------------
The remainder of the comments for this report are too long. To view
the rest of the comments, please view the bug report online at
http://bugs.php.net/14146
--
Edit this bug report at http://bugs.php.net/?id=14146&edit=1