Re: Configuration Directive Under Apache

> I am using Apache 1.3.24 with PHP 4.2.1. > > Using the new CHM version of the manual to configure PHP on a Windows 2000 > system with Apache 1.3.x, the "Installing PHP on Windows with Apache 1.3.x" > section of the manual instructs you to add the following two lines to the > httpd.conf file if you're installing PHP as a module: > > LoadModule php4_module c:/php/sapi/php4apache.dll > > AddType application/x-httpd-php .php .phtml > > While the above instructions are correct, you also have to add the following > line: > > AddModule mod_php4.c > > If you don't add this last line, the configuration testing facility shipped > with Apache informs you that it can't find the directive. This is there especially on that page in a note for a very long time now. | Note: You may find after using the windows installer for Apache that you | need to define the AddModule directive for mod_php4.c in the configuration | file (httpd.conf). This is done by adding AddModule mod_php4.c to the AddModule | list, near the beginning of the configuration file. This is especially | important if the ClearModuleList directive is defined. Failure to do this | may mean PHP will not be registered as an Apache module. Just read the manual ;) Goba