Re: PHP showing as Plain text in browser- PHP-Apache-Red Hat

I think the LoadModule and AddModule are correct. <IfDefine HAVE_PHP4>

LoadModule php4_module        modules/libphp4.so

</IfDefine> <IfDefine HAVE_PHP4> AddModule mod_php4.c </IfDefine> and I installed from an rpm binary not source. Guess I will have to go back and do it from source. Jens Rosenthal wrote:

Hi, do you have a line "LoadModule php4 ..." and "AddModule mod_php4.c" in your httpd.conf? Most likely you didn't activate the module so the fragment below doesn't do anything.. Otherwise did you compile the php4 module into apache? Jens -----Ursprüngliche Nachricht----- Von: Trevor Smith [mailto:trevor@whiprush.org] Gesendet: Freitag, 27. September 2002 14:59 An: php-install@lists.php.net Betreff: [PHP-INST] PHP showing as Plain text in browser- PHP-Apache-Red Hat As the subject says I have apache running on redhat and anything using php simply shows the Plain text code when I view it through a web browser. My AddType's from httpd.conf: <IfModule mod_php4.c>

       AddType application/x-httpd-php .php .php4 .php3 .phtml
       AddType application/x-httpd-php-source .phps

</IfModule> <IfModule mod_php3.c>

       AddType application/x-httpd-php3 .php3
       AddType application/x-httpd-php3-source .phps

</IfModule> <IfModule mod_php.c>

       AddType application/x-httpd-php .phtml

</IfModule> I think I have apache support enabled in php.ini currently this file is located in /etc, should it be somewhere else? ; Enable the PHP scripting language engine under Apache. engine = On any ideas would be appreciated -- PHP Install Mailing List (http://www.php.net/) To unsubscribe, visit: http://www.php.net/unsub.php