Re: Problems compiling PDO statically into PHP 5.0.4

Wez Furlong wrote:

Try following these instructions: http://netevil.org/node.php?uuid=420dc046-e4b8-6943-7672-20dc046b0eda

Thanks a lot Wez, works fine now! PDO works quite well with sqlite! I'm looking forward to PHP 5.1, great work! btw. I have written a script which reads data from xml (using simplexml) and writes them to sqlite (using pdo), the script is about 40% faster if I use PHP 5.1-dev instead of 5.0.4! best regards Andreas

On 6/7/05, Andreas Korthaus <akorthaus@web.de> wrote:

Hi! I postet this on php.general before, but I think it was not the right list.

I would like to compile PDO + PDO_sqlite statically into PHP 5.0.4. First I downloaded PDO-0.3.tgz and PDO_SQLITE-0.3.tgz and extracted them to /my/phpsrcdir/ext. I renamed the directories from "PDO-0.3" to "pdo" and from "PDO_SQLITE-0.3" to "pdo_sqlite". I tried to follow the instructions from the manual: http://www.php.net/manual/en/install.pecl.static.php so from /my/phpsrcdir I executed: ./buildconf --force But after this I tried ./configure --help | grep -i pdo without any results. So I did not know which ./configure parameters where necessary, so I extracted these .tgz-files to another location (not in /my/phpsrcdir) and used phpize to find out which ./configure parameters I need. So I found out that I have to use --enable-pdo --with-pdo-sqlite I did not expect it to work, but I tried to execute the following ./configure command: ./configure \ --prefix=/my/phpbindir/ \ --enable-pdo \ --with-pdo-sqlite \ --enable-memory-limit It did not fail, but after make && make install there is no pdo-support compiled in. What is going wrong here? What can I do? kind regards Andreas -- PECL development discussion Mailing List (http://pecl.php.net/) To unsubscribe, visit: http://www.php.net/unsub.php