Re: OCI8 , PHP and APACHE issue

I see that in both cases c:\PHP\php.ini is loaded. Are you sure that after trying the command line you didn't cut - paste the file to c:\windows? What do apache's and PHP's logs say? On Mon, Sep 1, 2008 at 1:25 PM, Jack van Zanen <jack@vanzanen.com> wrote: > Attached is phpinfo() both from the command line and from apache on the same > machine > > > I have done the exact same setup on my laptop and it works fine from apache > and cli. > I even copied over the httpd.conf and the php.ini file from my laptop as all > paths and versions were identical. > > Oracle 10.2.0.4 client > apache 2.2 > php 5.2.6 > > Thanks > > > On 01/09/2008, Evert Lammerts <evert.lammerts@gmail.com> wrote: >> >> Can you send your and the output of phpinfo when run from the command >> line and when run from the browser? >> >> On Mon, Sep 1, 2008 at 6:35 AM, Jack van Zanen <jack@vanzanen.com> wrote: >> > Hi List, >> > >> > >> > I have installed Oracle, PHP and apache on my windows machine and have >> > the >> > following issue >> > >> > If I run phpinfo() from the command line it shows OCI8 as enabled and I >> > can >> > connect to oracle databases. >> > >> > When I copy my php.ini to my windows directory (from my php directory) >> > and >> > start apache and than run phpinfo() from a php page in my browser it >> > does >> > not show me that OCI8 is enabled and also does not allow me to connect >> > to >> > databases. It does show it is using the right php.ini from my windows >> > directory >> > >> > I'm sure this must be an environment setting somewhere but I can't work >> > this out. >> > >> > Anybody with some more experience in configuring this combo can shed >> > some >> > light on this?? >> > >> > >> > >> > Brgds >> > >> > >> > Jack >> > > > > > -- > J.A. van Zanen