Re: OCI8 , PHP and APACHE issue
| From: | Evert Lammerts | Date: | Mon, 01 Sep 2008 12:31:55 +0000 |
| Subject: | Re: OCI8 , PHP and APACHE issue | ||
| References: | 1 2 3 4 5 | Groups: | php.db |
| Request: | Send a blank email to php-db+get-45298@lists.php.net to get a copy of this message | ||
No interesting entries in the logs?
On Mon, Sep 1, 2008 at 2:27 PM, Jack van Zanen <jack@vanzanen.com> wrote:
> I have the phpinidir directive set in apache so it loads the exact same
> php.ini as the cli
>
> Jack
>
> 2008/9/1 Evert Lammerts <evert.lammerts@gmail.com>
>>
>> I see that in both cases c:\PHP\php.ini is loaded. Are you sure that
>> after trying the command line you didn't cut - paste the file to
>> c:\windows? What do apache's and PHP's logs say?
>>
>> On Mon, Sep 1, 2008 at 1:25 PM, Jack van Zanen <jack@vanzanen.com> wrote:
>> > Attached is phpinfo() both from the command line and from apache on the
>> > same
>> > machine
>> >
>> >
>> > I have done the exact same setup on my laptop and it works fine from
>> > apache
>> > and cli.
>> > I even copied over the httpd.conf and the php.ini file from my laptop as
>> > all
>> > paths and versions were identical.
>> >
>> > Oracle 10.2.0.4 client
>> > apache 2.2
>> > php 5.2.6
>> >
>> > Thanks
>> >
>> >
>> > On 01/09/2008, Evert Lammerts <evert.lammerts@gmail.com> wrote:
>> >>
>> >> Can you send your and the output of phpinfo when run from the command
>> >> line and when run from the browser?
>> >>
>> >> On Mon, Sep 1, 2008 at 6:35 AM, Jack van Zanen <jack@vanzanen.com>
>> >> wrote:
>> >> > Hi List,
>> >> >
>> >> >
>> >> > I have installed Oracle, PHP and apache on my windows machine and
>> >> > have
>> >> > the
>> >> > following issue
>> >> >
>> >> > If I run phpinfo() from the command line it shows OCI8 as enabled and
>> >> > I
>> >> > can
>> >> > connect to oracle databases.
>> >> >
>> >> > When I copy my php.ini to my windows directory (from my php
>> >> > directory)
>> >> > and
>> >> > start apache and than run phpinfo() from a php page in my browser it
>> >> > does
>> >> > not show me that OCI8 is enabled and also does not allow me to
>> >> > connect
>> >> > to
>> >> > databases. It does show it is using the right php.ini from my windows
>> >> > directory
>> >> >
>> >> > I'm sure this must be an environment setting somewhere but I can't
>> >> > work
>> >> > this out.
>> >> >
>> >> > Anybody with some more experience in configuring this combo can shed
>> >> > some
>> >> > light on this??
>> >> >
>> >> >
>> >> >
>> >> > Brgds
>> >> >
>> >> >
>> >> > Jack
>> >> >
>> >
>> >
>> >
>> > --
>> > J.A. van Zanen
>
>
>
> --
> J.A. van Zanen
>