Re: Configure Command in phpinfo() (PHP4)
| From: | Marc Logemann | Date: | Sun, 25 Jun 2000 15:38:09 +0000 |
| Subject: | Re: Configure Command in phpinfo() (PHP4) | ||
| References: | 1 2 | Groups: | php.general |
| Request: | Send a blank email to php-general+get-2991@lists.php.net to get a copy of this message | ||
Troels Arvin wrote:
> Marc Logemann <logemann@handytotal.de> wrote:
> > where does the Configure Command String (3rd row in the table) in
> > phpinfo() comes from?
> From the configure switches that you gave for building the Apache module
> (if you are using an Apache module).
>
> > I removed the config.cache and config.status, without any success.
> Did you run a "make clean"?
>
ohh no, i just did it and yes its ok. thx.
So it was a different file than config.cache, hang
around unchanged and compiled into php each time.
Loge