RE: [PHP-INST] PHP install when apache already installed

Shaun If apache is already installed that's okay. The important thing is to carefully read the information in the 'INSTALL' file where you unpacked PHP - particularly the bit about 'DSO' and testing whether your installation of the web server supports this. If all is okay then you can start your build (of PHP) from step number 9 below. BTW the notes comment on using mysql as well so have a look at that while you're at it... good luck Tom Churchward Red Logic Oracle Support Specialists Tel: +44 (0) 161 831 9860 Fax: +44 (0) 161 831 9713 E-mail: tchurchward@redlogic.co.uk Web: www.redlogic.co.uk -----Original Message----- From: Shawn [mailto:sbeard@sdps.org] Sent: 28 February 2002 20:20 To: php-install@lists.php.net Subject: [PHP-INST] php install when apache already installed I need to have PHP installed on a AIX 4.3.3 machine that already has apache installed 1.3.20 I believe. the instructions for PHP's website for installing as a module seem to assume that you are installing apache at the same time. Do I have to re-compile and install apache to run PHP as a module? Here are the instructions I have. If I dont have to re-compile apache how do these instructions change? 1. gunzip apache_xxx.tar.gz 2. tar -xvf apache_xxx.tar 3. gunzip php-xxx.tar.gz 4. tar -xvf php-xxx.tar 5. cd apache_xxx 6. ./configure --prefix=/www --enable-module=so 7. make 8. make install 9. cd ../php-xxx 10. ./configure --with-mysql --with-apxs=/www/bin/apxs 11. make 12. make install If you decide to change your configure options after installation you only need to repeat the last three steps. You only need to restart apache for the new module to take effect. A recompile of Apache is not needed. 11. cp php.ini-dist /usr/local/lib/php.ini You can edit your .ini file to set PHP options. If you prefer this file in another location, use --with-config-file-path=/path in step 8. 12. Edit your httpd.conf or srm.conf file and check that these lines are present and not commented out: AddType application/x-httpd-php .php LoadModule php4_module libexec/libphp4.so You can choose any extension you wish here. .php is simply the one we suggest. You can even include .html, and .php3 can be added for backwards compatibility. The path on the right hand side of the LoadModule statement must point to the path of the PHP module on your system. The above statement is correct for the steps shown above. 13. Use your normal procedure for starting the Apache server. (You must stop and restart the server, not just cause the server to reload by use a HUP or USR1 signal.) -- PHP Install Mailing List (http://www.php.net/) To unsubscribe, visit: http://www.php.net/unsub.php