Re: PHP install when apache already installed

I get this error after running this: ./configure --with-mysql --with-apxs=/nim_svr/u01/oracle/product/7.1.7/Apach e/Apache/bin/abxs configure: error: can not find source in . or .. I get that error no matter what the configure options are. I tried it with out options too. Any ideas? "T Churchward" <tchurchward@redlogic.co.uk> wrote in message news:NGBBLJGBFAOCIMFJCNPLIELLCJAA.tchurchward@redlogic.co.uk... > Shaun > > If apache is already installed that's okay. The important thing is to > carefully read the information in the 'INSTALL' file where you unpacked > PHP - particularly the bit about 'DSO' and testing whether your installation > of the web server supports this. If all is okay then you can start your > build (of PHP) from step number 9 below. BTW the notes comment on using > mysql as well so have a look at that while you're at it... > > good luck > > > Tom Churchward > Red Logic > Oracle Support Specialists > > Tel: +44 (0) 161 831 9860 > Fax: +44 (0) 161 831 9713 > E-mail: tchurchward@redlogic.co.uk > Web: www.redlogic.co.uk > > > -----Original Message----- > From: Shawn [mailto:sbeard@sdps.org] > Sent: 28 February 2002 20:20 > To: php-install@lists.php.net > Subject: [PHP-INST] php install when apache already installed > > > I need to have PHP installed on a AIX 4.3.3 machine that already has apache > installed 1.3.20 I believe. the instructions for PHP's website for > installing as a module seem to assume that you are installing apache at the > same time. Do I have to re-compile and install apache to run PHP as a > module? Here are the instructions I have. If I dont have to re-compile > apache how do these instructions change? > > 1. gunzip apache_xxx.tar.gz > 2. tar -xvf apache_xxx.tar > 3. gunzip php-xxx.tar.gz > 4. tar -xvf php-xxx.tar > 5. cd apache_xxx > 6. ./configure --prefix=/www --enable-module=so > 7. make > 8. make install > 9. cd ../php-xxx > 10. ./configure --with-mysql --with-apxs=/www/bin/apxs > 11. make > 12. make install > > If you decide to change your configure options after installation > you only need to repeat the last three steps. You only need to > restart apache for the new module to take effect. A recompile of > Apache is not needed. > > 11. cp php.ini-dist /usr/local/lib/php.ini > > You can edit your .ini file to set PHP options. If > you prefer this file in another location, use > --with-config-file-path=/path in step 8. > > 12. Edit your httpd.conf or srm.conf file and check that these lines are > present and not commented out: > > AddType application/x-httpd-php .php > > LoadModule php4_module libexec/libphp4.so > > You can choose any extension you wish here. .php is simply the one > we suggest. You can even include .html, and .php3 can be added for > backwards compatibility. > > The path on the right hand side of the LoadModule statement must point > to the path of the PHP module on your system. The above statement is > correct for the steps shown above. > > > 13. Use your normal procedure for starting the Apache server. (You must > stop and restart the server, not just cause the server to reload by > use a HUP or USR1 signal.) > > > > > -- > PHP Install Mailing List (http://www.php.net/) > To unsubscribe, visit: http://www.php.net/unsub.php > >