RE: [PEAR] How to install a local copy of PEAR and after use it in a Hosting Service

Well: I execute go-pear.bat and siwtch Wide Installation. First: is that correct or I need to get local copy? Then I try to configure some parameters, but in two of them I have some doubts. The parameters are: 7. Name of configuration file : C:\WINXPSP2\pear.ini // leave there or change to another path 8. Path to CLI php.exe : D:\WebServer\PHP\. // what's that ?? Best ReynierPM Usuario registrado de Linux: #310201 ********************************************************* No basta con alcanzar la sabiduría, es necesario saber utilizarla. -----Original Message----- From: Norbert Mocsnik [mailto:lists@norbert.mocsnik.hu] Sent: Tuesday, December 13, 2005 11:12 AM To: Reynier Perez Mira Cc: pear-general@lists.php.net Subject: Re: [PEAR] How to install a local copy of PEAR and after use it in a Hosting Service Reynier Perez Mira wrote: > Hi again Norbert: > I see and I try to use it but I can see where setup proxy > configuration If you need to change any configuration settings, you can do them one-by-one AFTER config-create using a command like this: pear -c pear-config.ini config-set http_proxy example.com Usually there is no need to change these settings. -- Norbert Mocsnik http://norbert.mocsnik.hu/