Re: cvs: php4 /ext/standard file.c

I'm not sure. I tested it on my machine, it appears to take about 4 microseconds to set this signal to ignore and then restore it (a bit under 4 seconds for a million of those). I don't have stats how much the entire request startup process takes so I can't say if it's relative a lot or not, but off hand, it doesn't appear to be a very high number. Zeev At 19:59 23/12/2000, Stanislav Malyshev wrote:

ZS>> (c) Optionally, invoke the original signal handler if we're hit ZS>> by a signal while outside of the PHP scope. If under some ZS>> circumstances that won't work, tough luck. We can give this ZS>> option up completely too, as I haven't yet seen any other ZS>> modules that pay any attention to this signal. Is signal handler setting operation so slow we cannot do it on activate()? -- Stanislav Malyshev, Zend Products Engineer stas@zend.com http://www.zend.com/ +972-3-6139665 ext.115

-- Zeev Suraski <zeev@zend.com> CTO & co-founder, Zend Technologies Ltd. http://www.zend.com/