RE: [PHP-INST] Re-configure!

Hi again, Perhaps you install the php-binary in a different location than the "original" php binary brought to you by the system. This "original" binary mitght be the one you are calling, an not the brand new one.... Try a ls -la which php (note the backticks) to see which php binary you're calling and compare it to what you wanted to call. Jens -----Original Message----- From: Ben Lake [mailto:ben.lake@archose.com] Sent: Sunday, May 04, 2003 9:20 AM To: php-install@lists.php.net Subject: [PHP-INST] Re-configure! I am trying to reconfigure PHP 4.3.1 with additional --enable's but after I do the configure, make, make install, I do a php -m to see the modules I added and I get nothing. Even if I do a --disable-xml (since it is installed by default), it doesn't go away in php -m. What must I do to re-build PHP? I could have sworn I did this before. I originally compiled PHP when I had the 2.4.20-8 kernel under Redhat 9, but I was able to get it to compile under the 2.4.20-9 kernel and PHP updated the System line in phpinfo(); Any info would be appreciated. Ben