Bug #18374 Updated: Final stage of make fails

ID: 18374 Updated by: sniper@php.net Reported By: rtwick@utkalika.org -Status: Verified +Status: Closed Bug Type: Compile Failure Operating System: Redhat Linux 7.2 PHP Version: 4.3.0-dev New Comment: This bug has been fixed in CVS. You can grab a snapshot of the CVS version at http://snaps.php.net/. In case this was a documentation problem, the fix will show up soon at http://www.php.net/manual/. In case this was a PHP.net website problem, the change will show up on the PHP.net site and on the mirror sites. Thank you for the report, and for helping us make PHP better. Previous Comments: ------------------------------------------------------------------------ [2002-07-17 17:55:33] sniper@php.net When --disable-rpath is used, the compile fails (a bit differently, depending which configure options are used) ------------------------------------------------------------------------ [2002-07-17 17:03:49] sniper@php.net So the real reason for this failure was that you had runpaths disabled..I will test this myself now. ------------------------------------------------------------------------ [2002-07-17 15:40:01] rtwick@utkalika.org I upgraded automake, libtool and autoconf. But still got the same problem. However, I removed the --disable-rpath from the configure options and got a clean compile. ------------------------------------------------------------------------ [2002-07-17 13:52:13] sniper@php.net So you did NOT do './cvsclean' ??? That's very important.. If that doesn't make any difference, try updating libtool to 1.4.2 and automake to 1.5 (I have those and everything works :) ------------------------------------------------------------------------ [2002-07-17 13:49:07] rtwick@utkalika.org I'm sorry, the t1lib was actually specified with --with-t1lib=/usr/local not --with-t1lib=/usr/local/lib. Each time I run configure, I get fresh copy from cvs using the following commands cvs -d :pserver:cvsread@cvs.php.net:/repository login cvs -d :pserver:cvsread@cvs.php.net:/repository co php4 and then do a buildconf followed by configure and make. Here's my output from build/buildcheck.sh buildconf: checking installation... buildconf: autoconf version 2.13 (ok) buildconf: automake version 1.4-p5 (ok) buildconf: libtool version 1.4 (ok) ------------------------------------------------------------------------ The remainder of the comments for this report are too long. To view the rest of the comments, please view the bug report online at http://bugs.php.net/18374 -- Edit this bug report at http://bugs.php.net/?id=18374&edit=1